ASIO4ALL Official Home

Universal Windows ASIO Driver

Version 2.11 Beta 2

2.11 Release Candidate

Changes since version 2.11 Beta 1:

Make an effort to take back control over blocked (“unavailable”) audio devices.
Fix minor resource leak.
Fix regression in 2.11 Beta 1: Function of the “Always Resample” checkbox was inverted.
Remove excess outputlatency under the followingconditions: (1)64 bit host (2)upsampling 44.1 -> 48kHz (3)WaveRT polling mode.
Fix output audio glitches in 64 bit version when upsampling by integral factor.
Fix a4apanel64 crash on exit (not that anyone would have noticed).

ASIO4ALL 2.11 (Beta 2) Downloads ⮱

Posted

June 7, 2013

in

Newsroll, Version History

by

Michael Tippach

Tags:

Comments

Leave a Reply Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Advanced configuration

Once the control panel has been switched to advanced mode, things begin to look a little more complicated. The device list is now expandable and you can enable more than one item at a time. The device list contains Devices, Device Interfaces and so called “Pins”. Devices are independent hardware units most of the time.…
more
Device aggregation

Using the button next to each entry, you can now selectively enable/disable each particular item in the device list. This way, you can also create multi-device-setups (“aggregate devices”). Multi-device-setups require that all the devices involved are running from the same clock source. You can achieve this by daisy-chaining devices via S/PDIF etc. On-board devices usually…
more
Latency Compensation

Since ASIO4ALL does not have sufficient knowledge of the underlying hardware/driver architecture, it can only guess the actual latencies involved. With these sliders you can compensate for the latencies unknown to ASIO4ALL such that recordings in your sequencer Software are properly aligned with the rest. Note: In multi-device-setups the largest respective value of all devices…
more
Hardware Buffer on/off

Note: For WaveRT drivers, this box is labeled “Allow Pull Mode (WaveRT)” instead! Enables the hardware buffer for the highlighted device. This only works for so called “WavePCI” miniports, as other types of WDM drivers do not usually allow direct access to the hardware buffer. Adjustment for best hardware buffer performance involves the “ASIO Buffer…
more
Kernel Buffers/Buffer Offset

If hardware buffering is disabled, this control lets you add up to two more buffers to be queued for audio output. Each additional buffer increases the output latency of the device by the time it takes to play one buffer. Therefore, the initial setting of “2” should only be changed on less powerful machines, where…
more